- Mobile NO: +91 98336 40613
- Send Your Mail At: sales@adfastcomponents.com
Moly disulfide enables the coating to bear high loads. Even under low-slip velocities, moly can carry extreme loads.
The bolts are to be lubricated with molybdenum disulphide, an even better thread lube than phosphate and oil, and they will be tightened with a torque wrench.
| Standard | Test | Unit | Result |
|---|---|---|---|
| Consistency, density, viscosity | |||
| ISO 2137 | Unworked penetration | mm/10 | 320-370 |
| DIN 53 217 | Density at 20°C (68°F) | g/ml | 1 |
| DIN 51 562 | Base oil viscosity at40°C (104°F) | mm 2/s | 1,100 |
| Temperature | |||
| Service temperature | °C | -p3a0s tteo +650; effective to +300 | |
| °F | -22 to +1,202; effective to +572 | ||
| ISO 2176 | Drop point | °C | None |
| °F | None | ||
| Load-carrying capacity, wear protection, service life | |||
| DIN 51 350pt.4 | Four-ball tester Weld load | N | 2,500 |
| DIN 51 350 pt.5 | Wear factor under 800 N load | mm | 1.0 |
| Almen-WielandmachineOK load | N | >20,000 | |
| Coefficient of friction | |||
| Press-fit test µ = | 0.07 | ||
| Screw test: | |||
| Coefficient of friction of bolt connection M12, 8.8, blackened surface | |||
| – μ thread | 0.17 | ||
| – μ head | 0.10 | ||
| Initial break-away torque (M12 with starting torque Ma=80 Nm and heat treatment at 300°C/572°F, 21 h, bolt material: C 45, 8.8, mat.no. 1.0503) | Nm | 110 | |
| DIN 51 807 pt.1 | Water resistance, static, evaluation | 1 @ 90oC | |
| Corrosion protection | |||
| DIN 52 802 | SKF-Emcor method | ||
| Degree of corrosion | 0 | ||
Well-suited for all areas that need to be protected against water, steam and corrosion (e.g., brake mechanisms, flange seals, exhauster bolts).
Specification writers: These values are not intended for use in preparing specifications. Please contact your local MOLYKOTE® sales representative prior to writing specifications on this product.